Dbx DriveRack 220i User Manual download pdf (Page 15)

Configuration of the DriveRack units is done in Unit view. The DriveRack 220i configuration

can be changed by clicking on the CONFIG button. Once the CONFIG button has been

clicked, the modules can be changed by right clicking on the module to be changed. For

example, if you want to change the processing module in one of the inserts, you simply right-

click on that module and you will be able to select another processing block as well as unlink

that module (if it is stereo linked). To link modules in stereo, click on one of the module that

you want to link. While holding the Ctrl button click the other module that you want to link

it to; both modules should now be highlighted. By right-clicking on either module you can

now select LINK. Once the desired configuration is created you must click the CONFIG but-

ton once more to load the configuration.

To edit a processing module double click on that module. Adjust the module to taste; make

sure that the module is engaged, this is usually indicated by the module on button in the upper

left corner of the parameter section. Although process editing is done in real-time, the changes

can either be discarded or accepted by selecting the OK or CANCEL button.

Parameters can be copied and pasted between channels in the DriveRack devices. From the

program screen right click on the module that you want to copy and select Copy. To paste,

right click on a like module and select Paste. Obviously you cannot copy parameters to and

from unlike modules, for example from a Compressor to a Parametric EQ.

2. 6 - Copy and Paste

2. 5 - Editing

2. 4 - Configuration

Software Operation

Section 2

220i

DriveRack

User Manual

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 56 57

No comments

Dbx DriveRack 220i User Manual Page 15