Dbx DriveRack 220i User Manual download pdf (Page 11)

PC Connection

This DB-9 type connection is used to send and receive information to and from the computer

running the DriveWare™ software. Note: this connection is parallel with the DB-9 connection

on the rear panel.

Load Button

The load button is used to load the selected program.

Program Display

This program display is used to indicate the currently selected program of the 220i.

Program Up and Down (Filter Clear Ch1 and Ch2)

These program up and down buttons are used to scroll through the program menu of the 220i.

Pushing and holding these buttons will clear the live filters on these channels if there are AFS

modules in the signal path.

PC LED

This LED (when lit), indicates that the 220i is connected to the PC. When it is flashing, the 220i

is sending/receiving information from the PC.

CLIP LED

This LED (when lit), .indicates that a signal is clipping, either in the analog input section, or in

the DSP.

Input Meters

These meters monitor the signal level at the output of the A/D converter.

Threshold Meters

The threshold meters indicate indicate that the threshold level has been crossed within the out-

put dynamics section. The tri-color LED will be green when the signal is below the threshold

for a Compressor, Limiter and AGC, and above the threshold for the Gate. Yellow indicates

that the signal is in the over-easy region in the Compressor or Limiter and within the Window

of the AGC. Red indicates that the signal has passed over the threshold for the Compressor,

Limiter and AGC, or below the threshold for the Gate.

Output Meters

These meters monitor the signal level at the input of the D/A converter.

1.2 - Front Panel

Getting Started

Section 1

220i

DriveRack

User Manual

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 56 57

No comments

Dbx DriveRack 220i User Manual Page 11