Dbx iEQ 31 User Manual download pdf (Page 17)

iEQ User Manual

iEQ

Factory Hard Reset

In the event that you experience peculiar behavior with the iEQ or would like to set the Power-Up Mode

settings back to their factory default state, please perform the following Factory Hard Reset procedure:

• Power on the unit while pressing and holding the CHANNEL 2 <AFS> button until the

CHANNEL 2 meters display the LED pattern shown below, then release the button�

CHANNEL 2

Power Up Prompt

• Press and release the CHANNEL 1 <AFS> button until the CHANNEL 1 AFS button LED

is lit Yellow�

• To perform the Hard Reset, press and hold the CHANNEL 2 <AFS> button until all

CHANNEL 2 meter LEDs begin to flash, then release�

• To exit and return to normal operating mode, press and hold the CHANNEL 1 <AFS>

button until all CHANNEL 1 meter LEDs begin to flash, then release� The unit will take a

few seconds to reboot and will then be ready to operate� All settings will now be back to their

factory default state�

The iEQ’s factory default settings are as follows:

Power-Up Mode Menu Default Setting

System Lockout Unlocked

Live Filter Lift Time Live Filter Lift Off

AFS Normal vs� 6-Fixed/6-Live Mode AFS Normal Mode

Technical Information

1 2 ... 12 13 14 15 16 17 18 19 20

No comments

Dbx iEQ 31 User Manual Page 17